LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Hydraulic Brake System Actuation - F150) >> General Procedures >> Adjustable Pedal Indexing

Adjustable Pedal Indexing

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The adjustable pedal system must be indexed whenever the brake pedal assembly or accelerator pedal assembly is installed or damage to the components may result.
    NOTE: Make sure the electrical connector is connected to the adjustable pedal motor.
    Fig 1: Disconnecting Accelerator Pedal-To-Brake Pedal Cable From Adjustable Brake Pedal Gear Set
    G07404314Courtesy of FORD MOTOR CO.
  1. Disconnect the accelerator pedal-to-brake pedal cable from the adjustable brake pedal gear set.
  2. Operate the accelerator pedal to the full rearward position.
  3. Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
  4. Operate the adjustable pedals to the full forward position.
  5. Disconnect the adjustable pedal motor drive cable from the adjustable brake pedal assembly.
  6. Operate the adjustable accelerator pedal to the full forward position.
  7. Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
  8. Check that the brake and accelerator pedals can be fully adjusted forward and rearward.
scientia non olet · About LEMON Manuals