LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Hydraulic Brake System Actuation - F150) >> Diagnosis And Testing >> Inspection And Verification >> Adjustable Pedals

Adjustable Pedals

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART - WITHOUT MEMORY FEATURE

    Mechanical Electrical
    • Adjustable accelerator pedal and motor with cable attached
    • Adjustable brake pedal and bracket
    • Foreign objects or material
    • Wiring, terminals or connectors
    • Body Control Module (BCM) fuse(s):
      • 23 (15A)
      • 24 (15A)
    • Steering Column Control Module (SCCM)
    • Brake pedal control switch
    VISUAL INSPECTION CHART - WITH MEMORY FEATURE

    Mechanical Electrical
    • Adjustable accelerate pedal and motor with cable attached
    • Adjustable brake pedal and bracket
    • Foreign objects or material
    • BCM fuse(s):
      • 23 (15A)
      • 24 (15A)
    • Memory SET switch
    • Remote Keyless Entry (RKE) transmitter
    • SCCM
    • Wiring, terminals or connectors
    • Brake pedal control switch
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    4. NOTE: Make sure to use the latest scan tool software release.
  4. If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
    5. NOTE: The Vehicle Communication Module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.
  5. If the scan tool does not communicate with the VCM:
    • check the VCM connection to the vehicle.
    • check the scan tool connection to the VCM.
    • REFER to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • verify the ignition is ON.
    • verify the scan tool operation with a known good vehicle.
    • REFER to MODULE COMMUNICATIONS NETWORK to diagnose no response from the PCM.
  7. Carry out the network test.
    • If the scan tool responds with no communication for one or more modules, REFER to MODULE COMMUNICATIONS NETWORK .
    • If the network test passes, proceed with module self-test diagnostics.
  8. Carry out the self-test diagnostics for the SCCM, BCM and Driver Seat Module (DSM).
  9. If the DTCs retrieved are related to the concern, go to SCCM DTC Chart . For all other SCCM DTCs, REFER to STEERING COLUMN SWITCHES . For DSM DTCs, REFER to SEATING . For BCM and all other DTCs, REFER to MULTIFUNCTION ELECTRONIC MODULES .
  10. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .
scientia non olet · About LEMON Manuals