Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Always carry or place a live air bag module with the air bag and deployment door/trim cover/tear seam pointed away from the body. Do not set a live air bag module down with the deployment door/trim cover/tear seam face down. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
WARNING:
Never probe the electrical connectors on air bag, Safety Canopy® or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE:
The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE:
The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
- Depower the SRS. For additional information, Refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of this information.
- Remove the 3 passenger air bag module bolts.
- Partially remove the passenger air bag module from the instrument panel.
- Disconnect the 2 electrical connectors and remove the passenger air bag module.
NOTE:
Do not handle the passenger air bag module by grabbing the edges of the passenger air bag cover. Damage to the passenger air bag module may occur.