LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Parking Brake System - Parking Brake & Actuation - F150) >> Removal And Installation >> Parking Brake Cable - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the tension on the parking brake cable. For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE  .
  2. Remove the LH cowl side trim panel. For additional information, REFER to INTERIOR TRIM AND ORNAMENTATION .
    3. NOTE: The parking brake control take-up spool tab may need to be bent aside to allow the cable to be removed.
    Fig 1: Locating Parking Brake Control Take-Up Spool Tab
    G06167611Courtesy of FORD MOTOR CO.
  3. Disconnect the front parking brake cables from the parking brake control.
  4. Release the front parking brake cable conduit from the parking brake control.
  5. Detach the cable conduit grommet and remove the cable.
  6. To install, reverse the removal procedure.
    • Inspect the parking brake system for correct operation.
scientia non olet · About LEMON Manuals