LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Four Wheel Drive (4WD) Systems -- F150) >> Removal And Installation >> Integrated Wheel End (IWE) >> Installation

Integrated Wheel End (IWE): Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Compress the IWE and install a vacuum cap on the vacuum port.
    Fig 1: Installing Vacuum Cap On Vacuum Port
    G06171707Courtesy of FORD MOTOR CO.
    2. NOTE: Do not dislodge the Integrated Wheel End (IWE) seal spring when installing the IWE on halfshaft outboard end or component damage may occur.
  2. Install the IWE onto the halfshaft outboard end.
    3. NOTE: Allow the wheel knuckle to swing outward while keeping the halfshaft pushed inward.
  3. Once clearance is available, install the halfshaft outboard end into the wheel knuckle hub bearing.
  4. Connect the upper ball joint and install a new nut.
    • Tighten to 115 Nm (85 lb-ft).
  5. Connect the tie rod and install a new nut.
    • Tighten to 115 Nm (85 lb-ft).
  6. Position the front brake flexible hose bracket and install the bolt.
    • Tighten to 12 Nm (106 lb-in).
  7. Position the wheel speed sensor harness bracket and install the bolt.
    • Tighten to 12 Nm (106 lb-in).
  8. Install the 3 IWE-to-wheel knuckle retaining bolts.
    • Tighten to 12 Nm (106 lb-in).
  9. Remove the IWE vacuum cap and connect the vacuum tubes.
    10. NOTE: Verify the spline engagement by checking for spline lash before installing the axle nut or component damage may occur.
  10. Install the new axle nut.
    • Tighten to 40 Nm (30 lb-ft).
  11. Install the dust cap.
  12. Install the front wheel and tire. For additional information, REFER to WHEELS AND TIRES .
scientia non olet · About LEMON Manuals