LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Four Wheel Drive (4WD) Systems -- F150) >> Diagnosis And Testing >> Electronic Locking Differential (ELD) System >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
       
    • Rear axle assembly
    • Matching tire sizes
    • Battery Junction Box (BJB) fuses:
      • 20 (20A)
      • 29 (10A)
      • 54 (5A)
      • 68 (25A)
    • Body Control Module (BCM) fuse 34 (10A) (vehicles with ELD only)
    • Wiring, terminals or connectors
    • Mode Select Switch (MSS)
    • Electronic Locking Differential (ELD) field coil
    • Transfer Case Control Module (TCCM)
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    4. NOTE: Make sure to use the latest scan tool software release.
  4. If the cause is not visually evident, connect the scan tool to the DLC.
    5. NOTE: The VCM LED prove out confirms power and ground from the DLC are provided to the VCM.
  5. If the scan tool does not communicate with the VCM:
    • check the VCM connection to the vehicle.
    • check the scan tool connection to the VCM.
    • REFER to MODULE COMMUNICATIONS NETWORK , No Power To The Scan Tool, to diagnose no power to the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • verify the ignition is in the ON position.
    • verify the scan tool operation with a known good vehicle.
    • REFER to MODULE COMMUNICATIONS NETWORK to diagnose no response from the PCM.
  7. Carry out the network test.
    • If the scan tool responds with no communication for one or more modules, REFER to MODULE COMMUNICATIONS NETWORK .
    • If the network test passes, retrieve and record CMDTCs.
  8. Carry out the self-test diagnostics for the TCCM.
  9. If the DTCs retrieved are related to the concern, go to the TCCM DTC Chart  . For all other DTCs, REFER to MULTIFUNCTION ELECTRONIC MODULES .
  10. If no DTCs related to the concern are retrieved, GO to Symptom Chart - Electronic Locking Differential (ELD) System  .
scientia non olet · About LEMON Manuals