Stub Shaft Pilot Bearing and Seal: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Position the stub shaft pilot bearing in the axle tube or differential housing bore and using the Axle Shaft Oil Seal Installer, install the bearing.

Fig 1: Identifying Stub Shaft Pilot Bearing And Axle Shaft Oil Seal Installer
Courtesy of FORD MOTOR CO.
Carefully align the stub shaft pilot bearing oil seal with the housing bore and install the stub shaft bearing oil seal flush in the housing using the Wheel Speed Sensor Ring Installer and Handle.

Fig 2: Identifying Stub Shaft Bearing Oil Seal, Wheel Speed Sensor Ring Installer And Handle
Courtesy of FORD MOTOR CO.
Install a new circlip on the intermediate shaft end.

Fig 3: Locating Intermediate Shaft Circlip
Courtesy of FORD MOTOR CO.
Insert the intermediate shaft and engage the circlip with the differential side gear.
Install the halfshafts. For additional information, REFER to FRONT DRIVE HALFSHAFTS .