Differential Carrier: Installation

All vehicles 

1. Position the differential assembly in the axle housing.
   Fig 1: Identifying Differential Assembly In Axle Housing

   Courtesy of FORD MOTOR CO.
2. Install the original differential bearing shim on the LH side.

   ELD equipped vehicles 

3. Install the differential with the tabs on the ELD coil up against the differential bearing cap mounting surface.
   Fig 2: Locating Differential With Tabs On ELD Coil

   Courtesy of FORD MOTOR CO.
4. Push the ELD coil electrical connector through the differential case and connect the connector to the new adapter.
   Fig 3: Locating Connector Adapter

   Courtesy of FORD MOTOR CO.
5. Seat the connector adapter into the differential housing and install the bolt. Connect the electrical connector.
   • Tighten to 7 Nm (62 lb-in).
     Fig 4: Locating Bolt And Electronic Locking Differential Connector

     Courtesy of FORD MOTOR CO.

   All vehicles 

NOTE: Apply pressure toward the LH side to make sure the LH differential bearing cap is seated.
Fig 5: Locating Differential Bearing Cap And Bolts
Courtesy of FORD MOTOR CO.
6. Install the LH differential bearing cap and loosely install the 2 differential bearing cap bolts.
7. Install the original differential bearing shim on the RH side.
   Fig 6: Installing Differential Bearing Shim On RH Side

   Courtesy of FORD MOTOR CO.
8. Using the Shim Driver, fully seat the differential bearing shims.
   Fig 7: Seating Differential Bearing Shims

   Courtesy of FORD MOTOR CO.
9. Install the RH side differential bearing cap and tighten the 2 LH side and 2 RH side differential bearing cap bolts.
   • Tighten to 105 Nm (77 lb-ft).
     Fig 8: Locating Differential Bearing Cap Bolts

     Courtesy of FORD MOTOR CO.
10. Rotate the differential assembly to make sure it rotates freely.
    Fig 9: Rotating Differential Assembly

    Courtesy of FORD MOTOR CO.
11. Adjust the ring and pinion backlash. For additional information, refer to RING GEAR BACKLASH ADJUSTMENT  .
12. Install the axle shafts. For additional information, refer to AXLE SHAFT  .