LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Rear Drive Axle/Differential - Ford 9.75-Inch Ring Gear -- F150) >> In-Vehicle Repair >> Rear Wheel Bearing and Axle Shaft Seal >> Removal

Rear Wheel Bearing and Axle Shaft Seal: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the axle shaft. For additional information, refer to AXLE SHAFT  .
    2. NOTE: If only a new axle shaft oil seal needs to be installed, use care to avoid damaging the axle shaft oil seal bore.
  2. Using a suitable seal remover, remove and discard the axle shaft oil seal.
  3. Inspect the rear wheel bearing and axle shaft for wear or damage.
  4. Using the Axle Bearing Remover and Slide Hammer, remove the rear wheel bearing.
    Fig 1: Removing Rear Wheel Bearing
    G06166942Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals