LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Rear Drive Axle/Differential - Ford 9.75-Inch Ring Gear -- F150) >> In-Vehicle Repair >> Electronic Locking Differential (ELD) Field Coil >> Removal

Electronic Locking Differential (ELD) Field Coil: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential carrier. For additional information, refer to DIFFERENTIAL CARRIER  .
  2. Using the Bearing Puller plate, Step Plate and a suitable press, remove the LH differential bearing.
    Fig 1: Removing LH Differential Bearing
    G06166988Courtesy of FORD MOTOR CO.
  3. Remove and discard the 6 screws and 3 stoppers that hold the Electronic Locking Differential (ELD) coil in place and remove the coil.
    Fig 2: Locating Screws And Stoppers
    G06167052Courtesy of FORD MOTOR CO.
  4. Remove and discard the plunger assembly.
    Fig 3: Locating Plunger Assembly
    G06167053Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals