LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear -- F150) >> In-Vehicle Repair >> Rear Wheel Bearing and Axle Shaft Seal >> Installation

Rear Wheel Bearing and Axle Shaft Seal: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, lubricate the new rear wheel bearing with axle lubricant.
  2. If removed, use the Axle Bearing Installer and Handle to install the rear wheel bearing.
    Fig 1: Installing Rear Wheel Bearing
    G06166741Courtesy of FORD MOTOR CO.
  3. Lubricate the lip of the new axle shaft oil seal with grease.
  4. Using the Axle Oil Seal Installer and Handle, install the new axle shaft oil seal.
    Fig 2: Installing Axle Shaft Oil Seal
    G06166742Courtesy of FORD MOTOR CO.
  5. Install the axle shaft. For additional information, refer to AXLE SHAFT  .
scientia non olet · About LEMON Manuals