Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Manual and Power Columns

Remove the steering column shrouds. For additional information, REFER to STEERING COLUMN .
Disconnect the ignition switch electrical connector.
Manual Columns
Place the steering column tilt lever in the unlocked position.
Manual and Power Columns
Press the 2 locking tabs and remove the ignition switch.

Fig 1: Locating Ignition Switch Locking Tabs
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.