Normal Operation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
The Steering Column Control Module (SCCM) continuously monitors input voltage for correct operation. If voltage outside of defined limits is detected by the SCCM, the applicable DTC sets.
- DTC B119D:16 (Vehicle Battery: Circuit Below Threshold) - This DTC sets in continuous memory if the SCCM detects battery voltage below 8 volts on the battery voltage supply circuit.
This pinpoint test is intended to diagnose the following:
- Fuses
- Wiring, terminals or connectors
- Charging system
- Vehicle battery
- SCCM
NOTE:
Carry out a thorough INSPECTION AND VERIFICATION before proceeding with the pinpoint test. Refer to INSPECTION AND VERIFICATION
.
NOTE:
DTC B119D:16 can set if the vehicle battery has been discharged. The vehicle battery may become discharged due to excessive load(s) on the charging system from aftermarket accessories or if the battery has been left unattended with the accessories on.