Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 2 rear lamp assembly bolts.
- To install, tighten to 5 Nm (44 lb-in).
- Firmly pull the rear lamp assembly rearward to disengage the metal studs from the grommets on the outboard side of the sheet metal.
- Disconnect the electrical connectors.
- If necessary, rotate the bulb holder counterclockwise approximately one-eighth turn and remove it.
- Separate the bulb from the bulb holder.
- To install, reverse the removal procedure.