LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Exterior Lighting System - F150) >> Removal And Installation >> Headlamp Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel side finish panel.
    2. NOTE: The 3 retaining tabs on the headlamp switch are located at approximately 3, 6 and 11 o'clock positions when viewed from the front.
  2. Reaching from behind, release the 3 tabs and push the headlamp switch through the opening.
    • Disconnect the electrical connector.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals