Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

Remove the pin-type retainer and position the radiator side air deflector aside.

Fig 1: Locating Pin-Type Retainer
Courtesy of FORD MOTOR CO.

NOTE: Grasp the headlamp assembly firmly and pull forward to release the 2 metal clips.

Remove the 3 bolts and the headlamp assembly.
- Disconnect the electrical connectors.
To install, reverse the removal procedure.