Screen Method Aiming
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Horizontal aim is not adjustable for VOR headlamps.
NOTE:
Consult your state vehicle inspection information for recommended tolerance ranges for visual aiming.
- Before starting headlamp adjustment:
- check the tire inflation.
- check that no other load is in the vehicle other than a half tank of fuel.
- check that the headlamps are clean.
- check for correct headlamp operation.
- check that the vehicle is on level ground.
- if the vehicle is equipped with air suspension, make sure that the switch is on.
- Park the vehicle on a level surface approximately 7.6 m (25 ft) from the vertical wall or screen directly in front of it.
- Mark a horizontal reference line on the vertical wall or screen.
- Measure the center of the headlamp height to ground and record the measurement.
- Make a 2.4 m (8 ft) horizontal mark (using masking tape) on the vertical wall or screen at the same distance from the ground as previously recorded.
- Turn on the low beam headlamps to illuminate the wall or screen and open the hood.
- On the wall or screen, locate the high intensity area of the beam pattern.
- Identify at the top edge of this high intensity area a distinct horizontal cutoff in the beam pattern. If the top edge of this cutoff is not even with the horizontal reference line, the headlamp beam needs to be adjusted using the headlamp adjusting screw.
NOTE:
The vertical wall or screen must be a minimum of 2.4 m (8 ft) wide.
NOTE:
The center of the lamp is marked either on the lens (circle, crosshair or other mark) or on the bulb shield integrated into the lamp (crosshair or other mark).
NOTE:
This procedure should be done in a dark environment to effectively see the headlamp beam pattern.
NOTE:
The appearance of the VOR beam pattern may vary between vehicles.