LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (MULTIFUNCTION Electronic Modules - F150) >> Removal And Installation >> Upfitter Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Remove the instrument panel center finish panel. For additional information, REFER to INSTRUMENT PANEL AND CONSOLE .

    Vehicles with trailer brakes 

  2. Using a suitable tool (such as a small screwdriver), press the retaining tab at the top and remove the Trailer Brake Control (TBC) module.

    Vehicles without trailer brakes 

  3. Using a suitable tool (such as a small screwdriver), press the 4 retaining tabs and remove the storage bin.

    All vehicles 

  4. Using a suitable tool (such as a small screwdriver), press the 4 retaining tabs and remove the upfitter switch.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals