LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Information Center - Instrumentation, Message Center, And Warning Chimes - F150) >> General Procedures >> Compass Zone Adjustment >> Compass Calibration Zone Map

Compass Calibration Zone Map

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure is only applicable to vehicles without navigation. For vehicles with navigation, there is no compass zone adjustment.
Fig 1: Compass Calibration Zone Map
G06076691Courtesy of FORD MOTOR CO.
  1. Refer to the compass calibration zone map to select the correct compass zone setting for the geographic location of the vehicle.
  2. With the ignition in the ON position, press and hold the Front Controls Interface Module (FCIM) 7 and 9 buttons (for approximately 5 seconds) until the compass display shows the current zone setting (ZONE XX). Release the 7 and 9 buttons.
  3. Before the zone setting mode turns off (within 5 seconds), momentarily press and release the 7 and 9 buttons to increase the zone increment by one. Set the zone display number to match the vehicle geographical location on the compass calibration zone map.
  4. Release the 7 and 9 buttons for 5 seconds to exit the zone setting mode.
scientia non olet · About LEMON Manuals