Pinpoint Test As: The Turn Signal On Warning Chime Is Inoperative

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

AS1 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION
- Ignition OFF.
- With the ignition switch off and the key in the ignition lock cylinder, open the LH front door and observe the key-in-ignition warning chime operation.
- Does the key-in-ignition warning chime operate correctly?
  - Yes : GO to AS2.
  - No : INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) . TEST the system for normal operation.
AS2 CHECK THE TURN SIGNAL INDICATORS OPERATION
- Ignition ON.
- Verify the turn signal indicators operation.
- Do the turn signal indicators operate correctly?
  - Yes : GO to AS3.
  - No : GO to Pinpoint Test R .
AS3 CHECK THE ODOMETER FOR CORRECT OPERATION
- Drive the vehicle and observe the odometer for correct operation.
- Does the odometer operate correctly?
  - Yes : INSTALL a new BCM. REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation.
  - No : GO to Pinpoint Test H .