Ball Joint - Lower: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Remove the wheel knuckle. For additional information, refer to WHEEL KNUCKLE .
Remove and discard the lower ball joint snap ring.
Using the C-Frame and Screw Installer/Remover and Ball Joint Remover, remove and discard the lower ball joint.

Fig 1: Removing Lower Ball Joint
Courtesy of FORD MOTOR CO.

SVT Raptor
Using a clean shop towel and the specified surface cleaner, clean the lower arm ball joint bore and inspect for cracks or damage before installing a new ball joint. If there is evidence of cracks or damage, a new lower arm must be installed.