LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Front Suspension - Rear Wheel Drive (RWD) -- F150) >> Removal And Installation >> Ball Joint - Lower >> Removal

Ball Joint - Lower: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel knuckle. For additional information, refer to WHEEL KNUCKLE  .
  2. Remove and discard the lower ball joint snap ring.
  3. Using the C-Frame and Screw Installer/Remover and Ball Joint Remover, remove the lower ball joint.
    Fig 1: Removing Lower Ball Joint
    G06124816Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals