LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Power Steering System - F150) >> Removal And Installation >> Power Steering Fluid Reservoir >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: While repairing the power steering system, care should be taken to prevent the entry of foreign materials or failure of the power steering components may result.
  1. Using a suitable suction device, remove the power steering fluid from the fluid reservoir.
  2. Detach the wiring harness retainer from the power steering fluid reservoir stud bolt and position the wiring harness aside.
  3. Release the clamp and disconnect the power steering fluid reservoir-to-pump supply hose.
  4. Release the clamp and disconnect the power steering fluid cooler-to-power steering fluid reservoir hose.
  5. Remove the power steering fluid reservoir stud bolt and the power steering fluid reservoir.
    • To install, tighten to 8 Nm (71 lb-in).
  6. To install, reverse the removal procedure.
  7. Fill the power steering system. For additional information, REFER to STEERING SYSTEM - HYDRAULIC POWER ASSIST STEERING (HPAS) .
scientia non olet · About LEMON Manuals