Normal Operation: Notes
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
The generator current sensor is a Hall-effect sensor attached to the generator B+ cable. It is supplied a 5 volt reference and ground from the PCM. The PCM reads the generator current sensor feedback voltage to determine how much current is flowing through the generator B+ cable.
- DTC P0A5A (Generator Current Sensor Circuit Range/Performance) - The PCM does not detect current through the generator current sensor and there are no generator current sensor circuit DTCs are set.
- DTC P0A5B (Generator Current Sensor Circuit Low) - The PCM senses lower than expected voltage on the generator current sensor feedback circuit, indicating an open or a short directly to ground.
- DTC P0A5C (Generator Current Sensor Circuit High) - The PCM senses higher than expected voltage on the generator current sensor feedback circuit, indicating a short directly to voltage.
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Battery current sensor
- BCM