Valve Stem to Valve Guide Clearance

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOLS

	Clearance Gauge, Valve Guide 303-004 (TOOL-6505-E) or equivalent
	Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent

NOTE: Refer to the appropriate Engine information for the specification.

NOTE: The valve stem diameter must be within specifications before checking valve stem-to-valve guide clearance.

NOTE: If necessary, use a magnetic base.

Fig 1: Installing Valve Guide Clearance Gauge On Valve Stem And Install Dial Indicator Gauge With Holding Fixture

Courtesy of FORD MOTOR CO.

Install a Valve Guide Clearance Gauge on the valve stem and install a Dial Indicator Gauge with Holding Fixture. Lower the valve until the clearance gauge contacts the upper surface of the valve guide.
Move the Valve Guide Clearance Gauge toward the Dial Indicator Gauge with Holding Fixture and zero the Dial Indicator Gauge. Move the Valve Guide Clearance Gauge away from the Dial Indicator Gauge with Holding Fixture and note the reading. The reading will be DOUBLE the valve stem-to-valve guide clearance.