LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Engine Mechanical - 6.2L (2V) - F150) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH exhaust manifold. For additional information, refer to Exhaust Manifold - RH  .
  2. Remove the oil level indicator from the oil level indicator tube.
  3. Remove the oil level indicator and tube bolt.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Remove the oil level indicator tube from the cylinder block.
    • Discard the O-ring seal.
    5. NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.
  5. To install, reverse the removal procedure.
    • Install a new O-ring seal.
scientia non olet · About LEMON Manuals