LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Engine Mechanical - 6.2L (2V) - F150) >> In-Vehicle Repair >> Oil Cooler >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, REFER to JACKING & LIFTING .
  2. Drain the engine cooling system. For additional information, REFER to ENGINE COOLING .
  3. Remove and discard the oil filter.
  4. Disconnect the oil cooler coolant hose quick connect couplings and position aside. For additional information, REFER to FUEL SYSTEM - GENERAL INFORMATION .
    5. NOTE: If metal foreign material is present in the oil cooler, mechanical concerns exist. To diagnose mechanical concerns, REFER to ENGINE SYSTEM - GENERAL INFORMATION .
  5. Remove the threaded shaft and the oil cooler. Inspect the engine oil cooler.
scientia non olet · About LEMON Manuals