Crankshaft Rear Seal: Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Using the Rear Main Seal Installer and Handle, install a new crankshaft rear seal.
- With the inset hole on the crankshaft ignition pulse ring aligned with the inset hole on the crankshaft flange, install the crankshaft ignition pulse ring.
- Install the engine rear cover plate.
- Install the flexplate. For additional information, refer to Flexplate .
NOTE:
Lubricate the crankshaft rear seal with clean engine oil prior to installation.
NOTE:
Inspect the ignition pulse ring for damage. If the ignition pulse ring has been dropped or has any visual damage, it must be discarded.