Camshaft - RH: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Remove the timing drive components. For additional information, refer to Timing Drive Components .

NOTE: Damage to the camshaft phaser and sprocket assembly will occur if mishandled or used as a lifting or leveraging device.

NOTE: Only use hand tools to remove the camshaft phaser and sprocket assembly or damage may occur to the camshaft or camshaft phaser and sprocket.

Fig 1: Locating Camshaft Phaser And Sprocket Bolts

Courtesy of FORD MOTOR CO.

Using a 26 mm (1.023 in) wrench on the flats of the camshaft to secure the camshaft, remove the 3 RH camshaft phaser and sprocket bolts and the camshaft phaser and sprocket.
- Discard the 3 camshaft phaser and sprocket bolts.
Remove and discard the Variable Camshaft Timing (VCT) system oil filter.

Fig 2: Removing Variable Camshaft Timing (VCT) System Oil Filter
Courtesy of FORD MOTOR CO.

NOTE: The camshaft bearing caps must be installed in their original locations. Record camshaft bearing cap locations. Failure to follow these instructions may result in engine damage.

Remove the 10 bolts and remove the 5 camshaft bearing caps.
Remove the camshaft.
- Inspect the camshaft. For additional information, REFER to ENGINE SYSTEM - GENERAL INFORMATION .