LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine Mechanical - 5.0L (4V) - F150) >> In-Vehicle Repair >> Hydraulic Lash Adjuster >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
NOTE: If the components are to be reinstalled, they must be installed in their original locations. Mark the components for installation into their original locations.
  1. Remove the camshaft for the hydraulic lash adjuster being serviced. For additional information, refer to CAMSHAFT - RH  and/or CAMSHAFT - LH  .
  2. Remove the camshaft roller follower and hydraulic lash adjuster as an assembly.
  3. Separate the hydraulic lash adjuster from the spring clip on the camshaft roller follower.
  4. To install, reverse the removal procedure.
    • Lubricate the camshaft roller follower and hydraulic lash adjuster assembly with clean engine oil prior to installation.
scientia non olet · About LEMON Manuals