Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan, can cause engine failure.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, REFER to JACKING & LIFTING .
Remove the accessory drive and A/C compressor belts. For additional information, REFER to ACCESSORY DRIVE .
Remove the crankshaft pulley bolt and washer.
Using the 3 Jaw Puller and the crankshaft pulley bolt, remove the crankshaft pulley.
- Discard the crankshaft pulley bolt.
  
  Fig 1: Removing Crankshaft Pulley Using 3 Jaw Puller And Crankshaft Pulley Bolt
  Courtesy of FORD MOTOR CO.