LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine Mechanical - 5.0L (4V) - F150) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the engine front cover bore and the crankshaft front oil seal inner lip with clean engine oil.
    Fig 1: Installing Crankshaft Front Oil Seal Using Front Crank Seal And Damper Installer And Front Cover Oil Seal Installer (Plate Only)
    G07408875Courtesy of FORD MOTOR CO.
  1. Using the Front Crank Seal and Damper Installer and the Front Cover Oil Seal Installer (plate only), install the crankshaft front oil seal.
  2. Install the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY  .
scientia non olet · About LEMON Manuals