LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Mechanical - 3.7L - F150) >> In-Vehicle Repair >> Valve Spring, Retainer and Seal >> Installation

Valve Spring, Retainer and Seal: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the valve stem seal with clean engine oil prior to installation.
    Fig 1: Installing Valve Stem Seal
    G07958749Courtesy of FORD MOTOR CO.
  1. Using the Valve Stem Oil Seal Installer, install a new valve stem seal.
  2. Using the Valve Spring Compressors, install the valve spring, retainer and key.
    Fig 2: Installing Valve Spring, Retainer And Key
    G07958747Courtesy of FORD MOTOR CO.
  3. Install the valve tappets. For additional information, refer to VALVE TAPPETS  .
scientia non olet · About LEMON Manuals