Oil Cooler: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, REFER to JACKING & LIFTING .
Remove and discard the engine oil filter.
Using hose clamp pliers, clamp the 2 oil cooler coolant hoses and remove the 2 coolant hoses from the oil cooler.

Fig 1: Locating Oil Cooler Coolant Hoses Clamps
Courtesy of FORD MOTOR CO.
Loosen the oil cooler insert bolt and remove the oil cooler.
- Inspect the oil cooler gasket, replace if necessary.
  
  Fig 2: Locating Oil Cooler Insert Bolt
  Courtesy of FORD MOTOR CO.