Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, REFER to JACKING & LIFTING .
Remove the accessory drive belt and the A/C belt. For additional information, REFER to ACCESSORY DRIVE .
Using the Strap Wrench, remove the crankshaft pulley bolt and washer.
- Discard the bolt.
  
  Fig 1: Removing Crankshaft Pulley Bolt And Washer Using Strap Wrench
  Courtesy of FORD MOTOR CO.
Using the 3 Jaw Puller, remove the crankshaft pulley.
- Inspect the crankshaft pulley sealing surface for nicks or scratches that may effect the crankshaft front seal lip, replace the crankshaft pulley if necessary.
  
  Fig 2: Removing Crankshaft Pulley Using Jaw Puller
  Courtesy of FORD MOTOR CO.