LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Safety Belt System -- F250-F550 Super Duty) >> Diagnosis And Testing >> Safety Belt System >> Component Test >> Functional Test - Safety Belt Retractor, Automatic Locking Retractor (ALR) Mode

Functional Test - Safety Belt Retractor, Automatic Locking Retractor (ALR) Mode

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat backrest fully upright (if adjustable).
  2. Position the safety belt shoulder height adjuster (if equipped) in the full down or up position.
  3. Fasten the safety belt.
  4. Pull out the safety belt webbing until the Automatic Locking Retractor (ALR) feature is activated.
  5. Allow the safety belt webbing to retract until it stops.
  6. Pull on the safety belt webbing to check that the safety belt retractor has remained in the ALR mode. If the safety belt retractor is not locked, install a new safety belt retractor.
  7. Unfasten the safety belt and allow the safety belt webbing to retract to its stowed position.
  8. Pull out and retract the safety belt webbing to verify the safety belt retractor has converted automatically out of ALR mode. If the safety belt retractor remains locked in the ALR mode, install a new safety belt retractor.
scientia non olet · About LEMON Manuals