Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the license plate lamp harness from the rear bumper.
- If equipped, disconnect the rear park aid harness.
- Remove the 4 rear bumper-to-bracket nuts.
- To install, tighten to 115 Nm (85 lb-ft).
- Remove the 2 rear bumper bolts and retainers (1 each side).
- Remove the rear bumper from the vehicle.
- To install, reverse the removal procedure.
- Transfer all necessary components.
NOTE:
The aid of an assistant is required to remove the bumper.