Pinpoint Test K: All Passenger Windows Are Inoperative - LH And RH Rear, Crew Cab
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
- K1 CHECK THE VOLTAGE TO THE LH REAR WINDOW CONTROL SWITCH
- Disconnect: LH Rear Window Control Switch C717.
- Ignition ON.
- Measure the voltage between LH rear window control switch C717-3, circuit CPW14 (VT/WH), harness side and ground.
- Is the voltage greater than 10 volts?
NOTE: Set the window lock switch to the UNLOCK position.Fig 1: Measuring Voltage Between LH Rear Window Control Switch C717-3, Circuit CPW14 (VT/WH), Harness Side And GroundCourtesy of FORD MOTOR CO.
- Yes : GO to K3.
- No : GO to K2.
- K2 CHECK FOR AN OPEN BETWEEN THE LH FRONT AND LH REAR WINDOW CONTROL SWITCH
- Ignition OFF.
- Disconnect: LH Front Window Control Switch C566B.
- Measure the resistance between LH rear window control switch C717-3, circuit CPW14 (VT/WH), harness side and LH front window control switch C566B-4, circuit CPW14 (VT/WH), harness side.
- Is the resistance less than 5 ohms?
- Yes : INSTALL a new LH front window control switch. REFER to WINDOW CONTROL SWITCH . TEST the system for normal operation.
- No : REPAIR the circuit. TEST the system for normal operation.
- K3 CHECK THE LH FRONT WINDOW CONTROL SWITCH GROUND CIRCUIT FOR AN OPEN
- Ignition OFF.
- Disconnect: LH Front Window Control Switch C566B.
- Measure the resistance between LH front window control switch C566B-6, circuit GD137 (BK/WH), harness side and ground.
- Is the resistance less than 5 ohms?
- Yes : INSTALL a new LH front window control switch. REFER to WINDOW CONTROL SWITCH . TEST the system for normal operation.
- No : REPAIR the circuit. TEST the system for normal operation.