LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Transfer Case -- F250-F550 Super Duty) >> In-Vehicle Repair >> Transfer Case Shift Lever >> Removal

Transfer Case Shift Lever: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Shift the transfer case into 4H.
  3. Remove the shift lever boot and bezel. Slide the boot and bezel upward on the shift lever.
  4. Remove the 2 screws and the inner shift lever boot and bracket. Slide the boot upward on the shift lever.
  5. Remove the shift lever bolt that attaches the shift lever to the transfer case control. Remove the shift lever and the bezel and boot as an assembly.
  6. Disconnect the shift linkage from the lower shifter arm.
  7. Remove the transfer case control pivot bolt and the transfer case control bracket bolt, then remove the transfer case control assembly. Discard the pivot bolt.
scientia non olet · About LEMON Manuals