LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Wheel Hubs & Bearings - Full Floating Axle - DANA -- F350-F550 Super Duty) >> Diagnosis And Testing >> Wheel Bearings, Wheel Hub Seal and Wheel Bearing Cups >> F450 and F550 >> Installation

F450 and F550: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. For model 80, using the Rear Axle Drawbar and the Rear Wheel Hub Bearing Cup Installers 205-100 and 205-480, install the inner and outer bearing cups. For model S110 or S130, use a suitable driver.
    • Check to see if a 0.038 mm (0.0015 in) feeler gauge can be inserted between the cups and the rear hub at any point around each cup. Reseat the bearing cups, if necessary.
    Fig 1: Locating Inner And Outer Bearing Cups
    G07967674Courtesy of FORD MOTOR CO.
  2. Install the inner rear wheel bearing in the rear hub.
  3. Install a new rear hub seal.
    • For model 80, use a suitable seal installer.
    • For model S110 or S130, use the Wheel Hub Inner Wheel Installer and Adapter.
    Fig 2: Installing Rear Hub Seal
    G06136941Courtesy of FORD MOTOR CO.
  4. Position the rear brake disc on the rear hub and install the 8 bolts.
    • Tighten to 155 Nm (114 lb-ft).
    Fig 3: Locating Rear Hub Bolts
    G07967653Courtesy of FORD MOTOR CO.
  5. Install the rear wheel hub. For additional information, refer to Wheel Hub .
scientia non olet · About LEMON Manuals