LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Front Suspension - Four Wheel Drive (4WD) -- F250-F550 Super Duty) >> Removal And Installation >> Stabilizer Bar Bushing >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 4 stabilizer bar bracket nuts and the 2 stabilizer bar brackets.
    • Discard the nuts.
    • To install, tighten the new nuts to 48 Nm (35 lb-ft).
  3. Position the stabilizer bar to access the bushing.
  4. Remove the bushing.
    Fig 1: Removing Bushing
    G07967033Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals