LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Front Suspension - Rear Wheel Drive (RWD) -- F250-F550 Super Duty) >> Removal And Installation >> Track Bar >> Installation

Track Bar: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Tighten the track bar-to-frame bolt with the suspension at curb height or damage to the bushing may occur.
  1. Position the track bar and install the bracket nut and bolt. Do not tighten the nut at this time.
    2. NOTE: Use the hex-holding feature to prevent the track bar ball joint from turning while installing the nut, tighten the nut until snug. Final tighten the nut with the suspension at curb height or damage to the ball joint may occur.
  2. Position the track bar onto the ball joint and install the nut. Do not tighten the nut at this time.
  3. With the vehicle weight still supported by the jackstands, tighten the new track bar ball joint nut to 250 Nm (184 lb-ft).
  4. With the vehicle weight still supported by the jackstands, tighten the new track bar-to-frame bolt to 550 Nm (406 lb-ft).
scientia non olet · About LEMON Manuals