LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Front Suspension - Rear Wheel Drive (RWD) -- F250-F550 Super Duty) >> Removal And Installation >> Ball Joint >> Removal

Ball Joint: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel spindle or wheel knuckle assembly. For additional information, refer to Wheel Spindle - F250 & F350  or Wheel Knuckle - F450 & F550 .
  2. Remove the lower ball joint grease plug.
    Fig 1: Locating Lower Ball Joint Grease Plug
    G06136788Courtesy of FORD MOTOR CO.
  3. Position the wheel spindle in a vise and remove the snap ring from the lower ball joint.
    4. NOTE: To avoid damage to the components, do not use heat to aid ball joint removal.
    Fig 2: Removing Lower Ball Joint
    G06136789Courtesy of FORD MOTOR CO.
  4. Using the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover, remove the lower ball joint.
  5. Using the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover, remove the upper ball joint.
    Fig 3: Removing Upper Ball Joint
    G06597322Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals