LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Front Suspension - Rear Wheel Drive (RWD) -- F250-F550 Super Duty) >> Removal And Installation >> Axle - F250 & F350 >> Installation

Axle - F250 & F350: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the pivot bushing for wear or damage. Install a new bushing as necessary.
    2. NOTE: Tighten the axle pivot nut with the suspension at curb height or damage to the bushing may occur.
  2. Position the front axle into the pivot bracket, install the new pivot bolt and nut until snug.
  3. Install the radius arm. For additional information, refer to Radius Arm - F250 & F350 .
  4. Install the wheel spindle. For additional information, refer to Wheel Spindle - F250 & F350 .
  5. With the vehicle at curb height, tighten the new axle pivot nut to 175 Nm (129 lb-ft).
  6. Check and, if necessary, align the front end. For additional information, refer to SUSPENSION SYSTEM - GENERAL INFORMATION .
scientia non olet · About LEMON Manuals