LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Wheel Hubs & Bearings - Full Floating Axle - DANA -- F350-F550 Super Duty) >> Diagnosis And Testing >> Axle Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the parking brake.
  2. Remove the 8 axle shaft bolts.
    • To install, tighten to 133 Nm (98 lb-ft).
    Fig 1: Locating Axle Shaft Bolts
    G07967644Courtesy of FORD MOTOR CO.
  3. Remove the axle shaft.
    Fig 2: Locating Axle Shaft
    G07967645Courtesy of FORD MOTOR CO.
  4. Inspect the following components:
    • The O-ring for damage. Install a new O-ring as necessary.
    • The axle shaft for cracked material around the holes or oversized holes. Install new components as necessary.
    Fig 3: Locating O-Ring
    G07967542Courtesy of FORD MOTOR CO.
    5. NOTE: Lubricate the O-ring with premium long-life grease.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals