LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Automatic Transmission - 6R140 (TORQSHIFT(R)6)) -- F250-F550 Super Duty) >> Removal & Installation >> Manual Control Lever Shaft Seal >> Removal

Manual Control Lever Shaft Seal: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .
  2. Disconnect the selector lever cable end from the manual control lever.
    Fig 1: Locating Selector Lever Cable End Of Manual Control Lever
    G07482798Courtesy of FORD MOTOR CO.
  3. Remove the nut and remove the manual control lever.
    Fig 2: Locating Manual Control Lever Nut
    G07482832Courtesy of FORD MOTOR CO.
  4. Using a suitable tool, remove the manual shaft seal.
    Fig 3: Removing Manual Shaft Seal
    G07482833Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals