Internal Harness Service: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Lubricate the wiring harness bulkhead O-ring with clean transmission fluid and install the wiring harness bulkhead in the transmission case. Make sure the 2 tabs lock the bulkhead in the transmission case.

Fig 1: Locating Wiring Harness Bulkhead O-Ring And Tabs Lock
Courtesy of FORD MOTOR CO.
Connect the 7 solenoid electrical connectors, 2 speed sensor electrical connectors, TFT sensor electrical connector and the TR sensor electrical connector.

Fig 2: Locating Solenoid Electrical Connectors And Speed Sensor Electrical Connectors
Courtesy of FORD MOTOR CO.
Connect the selector lever cable end.

Fig 3: Locating Selector Lever Cable End Of Manual Control Lever
Courtesy of FORD MOTOR CO.
Install the transmission vehicle harness connector and lock the transmission vehicle harness connector by rotating the outer shell clockwise.

Fig 4: Locating Transmission Vehicle Harness Connector
Courtesy of FORD MOTOR CO.
Install the transmission fluid pan. Refer to TRANSMISSION FLUID PAN .