Transmission Case: Disassembly

All vehicles 

1. Using a punch, remove and discard the manual shaft-to-TR sensor roll pin.
   Fig 1: Locating Manual Shaft-To-TR Sensor Roll Pin

   Courtesy of FORD MOTOR CO.
2. Loosen the TR sensor detent spring bolt and the detent spring enough to remove the tension from the TR sensor.
   Fig 2: Locating TR Sensor Detent Spring Bolt

   Courtesy of FORD MOTOR CO.
3. Slide the manual shaft out and remove the TR sensor, park pawl actuator rod and the manual shaft.
   1. Manual shaft
   2. TR sensor
      Fig 3: Sliding Manual Shaft Out

      Courtesy of FORD MOTOR CO.
4. Remove the bolt and TR sensor detent spring.
   Fig 4: Locating TR Sensor Detent Spring Bolt

   Courtesy of FORD MOTOR CO.
5. Remove the park pawl pin plug.
   Fig 5: Locating Park Pawl Pin Plug

   Courtesy of FORD MOTOR CO.
6. Remove the park pawl pin and the park pawl.
   Fig 6: Locating Park Pawl And Pin

   Courtesy of FORD MOTOR CO.
7. Install the Rear Bearing Remover/Installer on the rear bearing with the Forcing Screw and remove the inner and outer output shaft bearings.
   Fig 7: Installing Rear Bearing Remover/Installer On Rear Bearing With Forcing Screw

   Courtesy of FORD MOTOR CO.

   Vehicles equipped with PTO 

8. Remove and discard the 6 PTO cover bolts, the PTO cover and gasket.
   Fig 8: Locating PTO Cover Bolts, PTO Cover And Gasket

   Courtesy of FORD MOTOR CO.