LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1310 (Parking Brake System - Parking Brake And Actuation - Vehicles With: Electronic Parking Brake (EPB)) >> Removal And Installation >> Park Brake Control Module (PBM) >> Installation

Park Brake Control Module (PBM): Installation

WARNING: This page is about a different car, the 2017 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. NOTE: Diagnostic trouble codes (DTC's) may be set when following these steps. This is normal and does not indicate a faulty module.

    Carry-out the following steps.

    1. Place the ignition switch in the ON position.
    2. Apply the parking brake.
    3. Cycle the ignition switch to the ON position, to the OFF position and then back to the ON position.
    4. Release the parking brake.

  3. Using a diagnostic scan tool carry-out the EPB Configuration Routine (also known as Apply and Release Test) following the diagnostic scan tool on-screen instructions.
  4. Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTC's)
scientia non olet · About LEMON Manuals