LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Fusion S, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 473 (Parking Brake System & Actuation -- F250-F550 Super Duty) >> Removal And Installation >> Parking Brake Control >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the tension on the parking brake system. For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE  in this section.
  2. Disconnect the parking brake switch electrical connector.
    Fig 1: Locating Parking Brake Switch Electrical Connector
    G04644534Courtesy of FORD MOTOR CO.
  3. Disconnect the parking brake release handle cable and conduit from the parking brake control.
    Fig 2: Locating Parking Brake Control
    G04644535Courtesy of FORD MOTOR CO.
  4. Remove the 3 parking brake control retaining nuts and position the parking brake control aside.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. Disconnect the hood release cable from the hood release handle.
  6. Position the parking brake cable and conduit grommet through the floor pan and remove the parking brake control.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals